Lost carburator part

Stefan K.
P6-Schüler

Beiträge: 25

I've lost this carburator part (red marked on picture), so now I can't start engine without putting some gasoline directly in carburator. Could you upload your picture of this part? Thanks.
[Link zum eingefügten Bild]

Alex
Moderator

Beiträge: 1107

As far as I can remember, this small part is made of plastic...!?

Stefan K.
P6-Schüler

Beiträge: 25

Yes, it's plastic, but I need the picture of it so I can make it or buy the similar one.

Thomas B.
registriert

Beiträge:

Hi,

what you are looking for looks like this:

[Link zum eingefügten Bild]

(Sorry about the poor quality of the pic)

It is needed for ventilation of the floating chamber of the carb. Also don't forget that there is a small spring in the carb housing to go together with this part. Without this spring, it is impossible to properly adjust the ventilation. However, you can produce this spring by dismanteling an old ballpen

If you want this plastic part, let me have your adress by email and i can send it to you by post.

All the best
Thomas

Version 3.1 | Load: 0.003278 | S: 1_14

Autor	Mitteilung
Stefan K. P6-Schüler Beiträge: 25	Gesendet: 19:28 - 03.11.2007 I've lost this carburator part (red marked on picture), so now I can't start engine without putting some gasoline directly in carburator. Could you upload your picture of this part? Thanks. [Link zum eingefügten Bild]
Alex Moderator Beiträge: 1107	Gesendet: 20:12 - 03.11.2007 As far as I can remember, this small part is made of plastic...!?
Stefan K. P6-Schüler Beiträge: 25	Gesendet: 22:10 - 03.11.2007 Yes, it's plastic, but I need the picture of it so I can make it or buy the similar one.
Thomas B. registriert Beiträge:	Gesendet: 10:43 - 06.11.2007 Hi, what you are looking for looks like this: [Link zum eingefügten Bild] (Sorry about the poor quality of the pic) It is needed for ventilation of the floating chamber of the carb. Also don't forget that there is a small spring in the carb housing to go together with this part. Without this spring, it is impossible to properly adjust the ventilation. However, you can produce this spring by dismanteling an old ballpen If you want this plastic part, let me have your adress by email and i can send it to you by post. All the best Thomas